Table of Contents
Advertisement
Available languages
Available languages
Glass Shelves
CAUTION
To avoid personal injury or property damage, handle
tempered glass shelves carefully. Shelves may break
suddenly if nicked, scratched, or exposed to sudden
temperature change.
Remove shelf by lifting front, releasing hooks from metal
track then pulling out. Place shelf on a towel. Allow shelf
to adjust to room temperature before cleaning.
Clean crevices by completing the following steps:
1.
Dilute mild detergent and brush solution into crevices
using a plastic bristle brush. Let set for 5 minutes.
2.
Spray warm water into crevices using faucet spray
attachment.
3.
Dry shelf thoroughly and replace shelf by inserting
hooks into metal track and lowering front.
Light Bulbs
WARNING
I
To avoidelectrical
shock which can cause severe
personal injury or death, disconnect p ower to
refrigerator before replacing light bulb. After replacing
light bulb, connect power.
CAUTION
To avoid personal injury or property damage, observe
the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
Upper refrigerator and non dispensing models freezer
section
Remove light bulb cover by removing ¼" (6 mm) hex
nut screws. Replace with an appliance bulb no
greater than 60 watts.
Replace light bulb cover by replacing ¼" (6 mm) hex
nut screws.
A
>
A
Light bulb cove_
B
Light butb
Lower refrigerator section (Some models)
Remove light bulb cover by removing screw. Replace
bulb with 40-watt tubular appliance bulb.
Replace light bulb cover by placing cover over light
bulb. Insert and tighten screw.
I
__
?'
/
/B
C
A
Light bulb
B
Light bulb covel
C
Sclew
Freezer section
1.
Remove ice bucket by lifting bucket and pulling out.
2.
Remove light bulb cover by removing screw. Replace
with an appliance bulb no greater than 60 watts.
3.
Replace light bulb cover by holding cover in place
over light bulb. Insert and tighten screw.
4.
Replace ice bucket by sliding in until bucket locks in
place.
----
A
A
Light bulb covel
B
Lighl bulb
Ice 'N Water
TM
dispenser (Some models)
Light bulb is located between dispenser arms.
Remove light bulb by unscrewing light bulb. Replace
light bulb with a 6-watt, 120-volt bulb.
Replace light bulb by inserting and tightening bulb.
15
Advertisement
Table of Contents
