Set Lock Code - JVC AV-65WP94 User Manual

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes
preset with a lock code of "0000".You may change the code to any four-digit number you wish.
To change the lock code, follow the steps below.
(_ Press the MENUbutton
AV To SET LOCK CODE
• • To operate (lock icon _ appears)
12 Press ZEROto access the lock code
The first digit will be highlighted
• • To select the number
J.V To move to the next digit
ii!l_ i!iL c _ i; _ c_! ii i ii ii i i i i i iiiiil iii i il iii i il iii i il iii i il iii i il iii i il iii i il i
ILOCK OODE OOOO.
PRESS _TO FINISH
Continue to follow these directions for all four numbers
12
I2
Press the OK button to finish (your lock code is now set)
Press the MENUbutton when finished
When a viewer attempts to watch a blocked channel, this message appears:
THis P ROGRAM EXCEEDS
YOUR RATING LIMITS. I
PLEASE ENTER LOCK CODE BY I
!0 KEY PAD TO UNLOC K
,o.
The channel will remain blocked until the correct lock code is entered (see above for
information on setting your lock code).
Notes:
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.
El