Advertisement
Removing
Collected
Water
1. Emptying the Bucket:
a. When the bucket
is full, the unit will shut down and the BUCKET FULL indicator
will illuminate.
_==ean filter
fitter
fan
reset
speed
humidity
setting
RH%
V
A
L humidity J
timer
ON-OFF
J
b.
Do not move the unit at this time otherwise
water
may spill on the floor.
c.
Press sides of bucket
gently
to undip
the bucket
from the unit.
d.
Remove the bucket
as shown
in the photographs
below
and empty
the bucket.
Discard
water
from bucket.
Water
is not potable
and cannot
be used for drinking.
e. Replace the empty bucket back into the unit and once seated correctly, the unit will start up again.
f.
You should hear a click when the bucket is in the correct position
If the bucket
full light does not extinguish,
check that the float
is correctly
snapped
in place as indicated
by the diagram.
The foam embedded under the float(shown
in the diagram below) is a functional part, which can not be removed.
@2009 Electrolux Home Products, Inc,
All rights reserved,
Advertisement
