Warning Indications - JVC GR-D250 Instructions Manual

40 EN IKUUI:fLI.:3HUUIIIVb
Warning Indications
• The viewfinder is pulled out and "PRIORITY" is
set to FINDER".
-) Push the viewfinder back in or set PRIORITY" to
LCD". (: pg. 18, 22, 25)
• The LCD monitor's brightness setting is toe dark.
-I.Adjust the brightness of the LCD monitor.
( pg. 15)
•-I.If the monitor is tilted upward 180 degrees, open
the monitor fully. ( pg. 18)
• A malfunction of some kind has occurred. In this
case the camcorder's functions become
unusable.
-.I. pg. 41.
Displays the battery remaining power.
Remaining power level
High Exhausted
As the battery power comes close to nil, the
battery remaining power indicator blinks.
When the battery power is exhausted, power
turns off automatically.
Appears when no tape is loaded. ( pg. 16)
Appears when the erase protection tab is set to
"SAVE" while the Power Switch is set to '_" or
"l_l". ( pg. 13)
[x_ll_-"] =l[o]II =f.._ #II #[_ [,7:!-"],.1:il I i :1
Appears if dirt is detected on the heads during
recording. Use an optional cleaning cassette.
( pg. 44)
Appears if condensation occurs. When this
indication is displayed, wait more than 1 hour
until condensation disappears.
Iq;1 ",,i_
Appears if a tape is not loaded when the
Recording Start/Stop Button or SNAPSHOT
Button is pressed while the Power Switch is set
to '_" or "F_'L
IIt;1",,i =i =1 _ID]
Appears when the tape ends during recording or
playback.
_"-] :111117.,1 i ;I1 IIIi'll I _
• Appears when the date/time is not set.
( pg. 14)
• The built-in clock battery has run out and the
previously set date/time has been erased.
Consult your nearest JVC dealer for
replacement.