JVC GR-D250 Instructions Manual page 25

1;_ SYSTEM
i-he "D SYSTEM" functions which are set when
:he Power Switch is set to "[]" are also applied
Nhen the Power Switch is set to "PLAY".
] = Factory-preset
d:l[.]:lili'i
]=1=1._
C)FF: Even though not heard while shooting,
_hutter sound is recorded on the tape.
BEEP: The beep sounds when the power is
:urned on or off, and at the beginning and end of
"ecording. It also activates the shutter sound
_ffect.( pg. 29)
[MELODY]: Instead of a beep, a melody sounds
Nhen any operation is performed. It also
activates the shutter sound effect. ( - pg. 29)
_.'1 lVil ll tc."]il I
1_llVl[l) i i
[:)FF: Disables the remote control operations.
[ON]: Enables the remote control operations.
t is recommended that this function be set to
'OFF" to prevent improper operation.
]=hVjEo3 ILV_[o3 D]_
C)FF: Automatic demonstration will not take
31ace.
:ON]: Demonstrates certain functions such as
Program AE with special effects, etc., and can
3e used to confirm how these functions operate.
Demonstration starts in the following cases:
i When the Menu Screen is closed after DEMO
MODE" is turned ON".
i With "DEMO MODE" set to "ON", if there is no
operation for about 3 minutes after the Power
Switch is set to '1_" or '_]".
i Performing any operation during the
demonstration stops the demonstration
temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will
resume.
NOTES:
I If a cassette is in the camcorder, the
demonstration cannot be turned on.
i DEMO MODE" remains "ON" even if the
camcorder power is turned off.
i If "DEMO MODE" remains "ON", some functions
will not be available. After viewing demo, set to
OFF".
s,a_tvuJ run u_xL_u _u_uJfs,l_tv_ EN _'D
[LCD]: The image is displayed on the LCD
monitor when the viewfinder is pulled out while
the LCD monitor is opened.
FINDER: The image is displayed in the
viewfinder when the viewfinder is pulled out
while the LCD monitor is opened.
EXECUTE: Resets all settings to the factory-
preset.
[RETURN]: Does not reset all settings to the
factory-preset.