JVC GR-D250 Instructions Manual page 17

wuL_ _L.L_U_VU
EN I I
I BasicRecording
NOTE:
3efore continuing, perform the procedures listed
)elow:
DPower (pg+ 11)
DLoading A Cassette (pg+ 16)
-- Power Zoom Lever
Power Switch
Lock Bu_on
Tape Remaining Time
Approximate tape remaining 0 h 25m
time appears on the display. "-h--m"rneansthe
camcorder is calculating the
remaining time. When the
remaining time reaches 2 minutes+ the indication
starts blinking.
• The time required to calculate and display the
remaining tape length, and the accuracy of the
calculation, may vary according to the type of tape
used.
POWER/CHARGE Lamp
Recording Start]Stop Button
1 Remove the lens cap.( pg. 10)
2 Open the LCD monitor fully+
3 Set the Power Switch to '_" or "1_" while
3ressing down the Lock Button located on the
switch+
DThe POWER/CHARGE lamp lights and the
camcorder enters the Record-Standby mode.
PAUSE" is displayed.
DTo record in LP (Long Play) mode, pg. 23.
4 To start recording+ press the Recording Start/
Btop Button. '_... REC" appears on the display
Nhile recording is in progress.
5 To stop recording, press the Recording Start/
Btop Button again. The camcorder re-enters the
qecord-Standby mode.
Approximate recording time
Recording mode
Tape
SP LP
_0min+ 30 min. 45 min.
;0 min+ 60 min. 90 min.
;0 min+ 80 min. 120 min.
NOTES:
DIf the Record-Standby mode continues for
5 minutes, the camcorder's power shuts off
automatically. To turn the camcorder on again,
push back and pull out the viewfinder again or
close and re-open the LCD monitor.
DWhen a blank portion is left between recorded
scenes on the tape, the time code is interrupted
and errors may occur when editing the tape. To
avoid this, refer to Recording From The Middle Of
A Tape" ( pg. 19)+
DTo turn the beep sounds off, pg. 22, 25+