Jenn-Air SVD48600P Use And Care Manual page 17

Gas-electric grill-range with convection oven

Hide thumbs Also See for SVD48600P:

Enlarged version

The grill consists of two black grill grates and a grill burner.

Only install the grill on the

left side of your range.

To Install Grill Module

1. Before installing grill components,

be certain control knobs are in the Off position.

2. Position the grill burner

with mixer tube openings toward the orifices.

Slide the

burner towards the orifices until the igniter is in between front and rear grill sections.

Lower into place until side openings are resting on the burner support pins.

3. Place the grill grates on the top of the rangetop.

NOTE:

Before using the grill for the first time, heat the E-yen Heat

grill burner to

remove the protective shipping coating. Heat the grill on Hi for 10 minutes and

use the vent system to remove any additional smoke during cooling.

To Remove

Grill Module

1. Be sure control knobs are in the Off position. Remove grill components once they

are cool.

2. Remove grill grates.

3. Lift the grill burner up off the support pins about 2 inches,

Slide the burner away

from the orifices.