TROUBLE-SHOOTING
AND MAINTENANCE
Inspect and tighten all parts each time you use the stepper. The stepper can be cleaned using a soft
cloth and mild, non-abrasive detergent. Do not allow liquid to come in contact with the electronic
monitor.
CONSOLE
If the console displays incorrect feedback, or if the displays become faint, the batteries should be
replaced. See assembly step 4 on page 5 for battery installation instructions.
If the console displays incorrect feedback after the batteries
are replaced, the Reed Switch (25) should be checked.
Remove the two 3/8" x 4" Carriage Bolts (42), 3/8" Flat
Washers (43), and 3/8" Nylock Nuts (44) from the Upright
(47). Lift the Upright off the Base (49). Be careful not to
damage the Wire Harness (22). Disconnect the Wire
Harness from the console wire. Remove the three #8 x 3/4"
Tec Screws (29) from the Hood (28) and remove the Hood.
Push down the Left Pedal (18) so that the Magnet (13)
passes the Reed Switch. Loosen the #8 x 3/4" Tec Screw
(29) shown in the inset drawing. Adjust the Reed Switch
(25) so that there is a 3/16" gap between the Reed Switch
and the Magnet. Reassemble the Hood (28), wires, and
Upright (47).
8