Maintenance And Trouble-Shooting; Part List; Ordering Replacement Parts - LIFESTYLER ST210 User Manual

MAINTENANCE AND TROUBLE-SHOOTING
Regularly inspect and tighten all parts of the stepper. The stepper can be cleaned using a soft cloth and mild,
non-abrasive detergent. Do not allow liquid to come in contact with the electronic monitor.
ELECTRONIC MONITOR
if the electronic monitor displays incorrect feedback, or if the display
becomes faint, the batteries should be replaced. See BATTERY
INSTALLATION on page 8 for battery installation instructions.
If the electronic monitor still displays incorrect feedback, the Reed
Switch (10) in the Upright (6) should be repositioned. Raise the
Right Pedal (18) until the Magnet (33) is aligned with the Reed
Switch, Slide the Reed Switch in or out of the Upright until there is a
1/4" gap between the Reed Switch and the Magnet. Do not push
the Reed Switch completely Into the Upright.
If the Electronic Monitor (1) displays no feedback when the STEPS
PER MINUTE or CALORIE mode is selected, the Sensor Wire (10)
should be checked. Remove the four #8 x 112"Screw (3) attaching
the Monitor to the Handlebar Plate (2). Make sure that the Sensor
Wire is plugged fully into the wire extending from the Monitor,
Reattach the Monitor to the Handlebar Plate.
-2
PART LISTmModel No. 831.285740
R0795A
Key No. Part No. Qty. Description Key No. Part No. Qty. Description
1
2
3
4
5
6
8
9
10
11
12
13
14
15
16
17
119136 1 Electronic Monitor 18 125046 1 Right Pedal
120607 1 Handlebar Plate 19 125045 1 Left Pedal
013423 4 #8 x 112' Screw 20 121894 1 Base
120612 1 Left Handlebar 21 121600 1 Stabilizer
120615 1 Right Handlebar 22 013266 2 M8 x 90ram Bolt
120613 1 Upright 23 012042 2 M8 Nylon Locknut
121996.5_(, 2 Resistance Cylinder 24 121050 4 M10 Nylon Locknut
120610 2 Handlebar Bushing 25 121043 2 M10 Pl_e Screw
121518 2 MIO x 1.5ram Screw 26 121049 2 Bumper
125047 1 Reed Switch/Sensor Wire 27 121475 1 Water Bottle
100151 2 5/8" Dome Cap 28 120757 1 Water Bottle Bracket
121596 2 5/8" Cylinder Spacer 29 119887 1 Grommet
121047 2 M4 Bracket Screw 30 01.3222 4 M4 Screw
121607 2 21mm Washer 31 121044 2 M5 Screw
121599 4 Endcap 32 121519 2 20ram Lock Washer
120818 4 Pedal Bushing 33 113349 1 Magnet/Retainer
121603 2 Pedal Cover # 123569 1 User's Manual
10 Note: "#" indicates a non-illustrated part. See the back cover for information about ordering replacement parts.