ICP PGS524 Owner's Manual
ICP PGS524 Owner's Manual

ICP PGS524 Owner's Manual

Packaged gas heat/electric cooling units

Advertisement

Packaged Gas Heat/Electric Cooling Units
Owner's Guide to Operating and
Maintaining Your Gas/Electric
Unit
ELECTRICAL SHOCK HAZARD.
Failure to follow
this warning could result in
personal injury, death, and/or property damage.
Disconnect
power at fuse box or service panel
before performing recommended
maintenance.
FIRE,
EXPLOSION,
ELECTRICAL
SHOCK
HAZARD.
Failure to follow
this warning could result in
personal injury, death, and/or property damage.
Do not use this unit if any part has been under
water.
Immediately
call
a qualified
service
technician to inspect the unit and to replace any
part of the control system which has been under
water.
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly could
result in serious injury, death, and/or property
damage.
Information
in this manual MUST be followed
exactly.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
Leave the building immediately.
• Do not try to light any appliance.
• Do touch any electrical switch; do not use any
phone in the building.
• Immediately
call your
gas supplier
from
a
neighbors
phone.
Follow
the gas suppliers
instructions.
• If you cannot reach your gas supplier, call the
fire department.
Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
This manual should be left with the owner.
04/28/09
462 02 2102 00

Advertisement

Table of Contents
loading

Summary of Contents for ICP PGS524

  • Page 1 Packaged Gas Heat/Electric Cooling Units Owner's Guide to Operating and Maintaining Your Gas/Electric Unit ELECTRICAL SHOCK HAZARD. FIRE OR EXPLOSION HAZARD Failure to follow this warning could result in Failure to follow safety warnings exactly could personal injury, death, and/or property damage. result in serious injury, death, and/or property damage.
  • Page 2: Unit Introduction

    SAFETY CONSIDERATIONS Improper installation, adjustment, alteration, service maintenance, or use can cause explosion, fire, electrical ELECTRICAL SHOCK HAZARD shock, or other conditions which may cause death, Failure to follow this warning could result in personal injury personal injury, or property damage. Consult a qualified and/or death.
  • Page 3: Fire And Explosion Hazard

    the ignitionmodule will go intoa RetryModeaftera To Shut Off Unit Gas Heat: periodof approximately 22 seconds (following t he 5 second ignition period). Iftheburners donotlight w ithin 15minutes o ftheinitial c allforheat, t hereis a lockout. FIRE, EXPLOSION, ELECTRICAL SHOCK HAZARD 11.Setthe temperature s elector o n roomthermostat to desired setting.
  • Page 4: Maintenance And Service

    To better protect your investmentand to eliminate Air Filters unnecessary servicecalls,familiarize yourself withthe The air filter(s) should be checked every 3 or 4 weeks and following facts: changed or cleaned whenever it becomes dirty. Dirty filters produce excessive stress on the blower motor and can Cooling Mode cause the motor to overheat and shut down.
  • Page 5 FIGURE 3 To Start Unit Gas Heat MAIN ,,1,-.-..- STEP1 STEP STEP STEP4 STEP 5 STEP6 STEP MAIN STEP 8 STEP 9 STEP 10...
  • Page 6 FIGURE 4 To Shut OFF Unit Gas Heat MAIN ° STEP1 STEP2 STEP 3 STEP 4 STEP 5 STEP 6...
  • Page 7 FIGURE 5 To Start Unit Electric Cooling MAIN STEP 1 STEP 2 STEP 3 STEP 4 & 5 FIGURE 6 To Shut OFF Unit Electric Cooling MAIN STEP3 STEP2 STEP...
  • Page 8: Burn Hazard

    Fans and Fan Motors Unit Panels Periodically check the condition of fan wheels and housings After performing any maintenance or service on the unit, be and fan-motor shaft bearings. Contact your dealer for the sure all panels are fastened securely in place to prevent rain required annual maintenance.
  • Page 9 5.Inspection a nd,if required, c leaning oftheindoorcoil Beforeyoucall for service... condensate d rain..check f orseveral e asily-solved p roblems. 6.Inspection a ndcleaning of blower w heelhousing and If insufficient heating or cooling is suspected: motor. ( ) Check the air filter for dirt. 7.Inspection of all supply-airand return-airductsfor leaks, obstructions, a nd insulationintegrity.Any ( ) Check for blocked return-air...

Table of Contents