Download Print this page

Husqvarna 917.289610 Owner's Manual page 22

Yth2042
Hide thumbs Also See for 917.289610:

Advertisement

SERVICE AND ADJUSTMENTS
REPLACING
BATTERY
(See Fig. 36)
WARNING:
Do not short battery termi=
nals by allowing a wrench or any other
object to contact both terminals
at the
same time. Before connecting battery,
remove
metal
bracelets,
wristwatch
bands,
rings,
etc.
Positive terminal
must be connected
first
to prevent
sparking from accidental
grounding.
Lift seat pan to raised position.
Disconnect BLACK battery cable first then RED battery
cable and carefully remove battery from tractor.
Install new battery with terminals in same position as
old battery.
First connect RED battery cable to positive (+) terminal
with bolt and nut as shown. Tighten securely. Slide
terminal cover over terminal.
Connect BLACK grounding cable to negative (-) ter-
minal with remaining bolt and nut. Tighten securely.
Lower seat pan.
SEAT PAN
TERMINAL
COVER
NUT
BOLT
POSITIVE
(RED)
Fig. 36
NEGATIVE
(BLACK)
CABLE
TO REPLACE
HEADLIGHT
BULB
Raise hood.
Pull bulb holder out of the hole in the backside of the
grill.
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
Checkwiring. See electrical wiring diagram in the Repair
Parts section.
TO REPLACE
FUSE
Replace with 20 amp automotive-type
plug-in fuse. The
fuse holder is located behind the dash.
TO REMOVE
HOOD AND GRILL ASSEMBLY
(See Fig. 37)
Raise hood.
Unsnap headlight wire connector.
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
To replace, reverse above procedure.
HOOD
HEADLIGHT
WIRE
CONNECTOR
Fig. 37
TRANSMISSION
REMOVAL/REPLACEMENT
Should your transmission
require removal for service or
replacement,
it should be purged after reinstallation and
before operatingthetractor. See"PURGETRANSMISSION"
in the Operation section of this manual.
ENGINE
TO ADJUST
THROTTLE
CONTROL
CABLE
The throttle control has been preset at the factory and
adjustment should not be necessary. If adjustment is nec-
essary, see engine manual.
TO ADJUST
CHOKE
CONTROL
The choke control has been preset at the factory and adjust-
ment should not be necessary. If adjustment is necessary,
see engne manual.
TO ADJUST
CARBURETOR
Your carburetor is not adjustable. If your engine does not
operate properly due to suspected carburetor problems,
take your tractor to an authorized service center for repair
and/or adjustment.
22

Advertisement

loading

This manual is also suitable for:

Yth2042