How To Use The Spray Tips - Husqvarna 1906 Owner's Manual

Operation
How to Use the Spray Tips
The quick-connect on the nozzle extension allows you to
switch between five different spray tips. The spray tips vary
the spray pattern as shown below (Figure 7).
CAUTION
NEVER exchange spray tips without locking the safety latch
on the trigger.
Follow these instructions to change spray tips:
I. Engage safety latch on spray gun.
2. Pull back collar on quick-connect and pull current
spray tip off. Store spray tips in space provided on
handles storage panel.
3. Select desired spray tip:
For gentle rinse, select white 40 ° or green 25 °
spray tip.
To scour surface, select yellow 15+ or red 0° spray
tip.
To apply chemical, select black spray tip.
4. Pull back on collar, insert new spray tip and release
collar. Tug on spray tip to make sure it is securely in
place.
5. For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface. If you get spray
tip too close, you may damage cleaning surface. DO
NOT get closer than 6 inches when cleaning tires.
Cleaning and Applying Chemical
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
CAUTION
• Startingthe engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instructionwill void warranty.
To apply detergent follow these steps:
I. Review spray tip use.
2. Prepare detergent solution as required by manufacturer.
3. Place chemical injection siphon/fitter into detergent
container.
CAUTION
•
When insertingthe filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently contacting
the hot muffler.
4. Make sure black spray tip is installed.
NOTE: Detergent cannot be applied with the high
pressure spray tips (White, Green, Yellow, or Red).
Low Pressure \
Use to apply
chemical
High
Pressure
Black White Green Yellow Red
40 ° 25 ° 15 + 0 °