Table of Contents
Advertisement
[ VIEWING THE PICTURE PLAYED BACK ON YOURTV
1. Connect
the AV stereo output cord (Provided)
to "AUDIO
IN" and "VIDEO
IN" of your
TV.
2. Connect
the other end of the AV stereo output cord to "AV IN/OUT"
of your
camera/recorder.
3. Turn on TV.
4. Perform same procedures
in steps 4 through
7 of "Example
1" above.
Example
3: If your TV is a regular TV,
Camera
hookup to regular TV Illustration
1. Disconnect
the VHF antenna
leads from the rear of the TV receiver.
[NOTE:
Leave the UHF antenna
leads connected
tothe
TV.
2. Connect
the VHF antenna
lead to "IN FROM ANT" on the RF output adapter.
3. Connect
the 75-ohm coaxial cable to "OUT TO TV" on the RF output adapter.
4. Connect
the other end of the VHF antenna terminal
on the TV, as illustrated.
5. Connect
the connector
cable from RF output adapter to "AV IN/OUT" jack on the
camera/recorder.
6. Turn on the TV and set to channel
3 unless channel
3 is one of the TV stations
in
your area. If channel
3 is used in your area, set your TV to channel 4.
7. Set the RF channel select switch on the RF output adapter to "CH3" or "CH4" to
match the channel selector
on your TV.
8. Perform same procedures
in steps 4 through
7 of "Example
1" on page 38.
NOTE: If you want to watch a TV program with camera!recorder
connected
as illustrated,
1
turn operate Control of the Camera/recorder
to off.
1
Advertisement
Table of Contents
