Hitachi VM-SP1A Instruction Manual page 25

8mm video camera/recorder
Table of Contents

Advertisement

1. Plug the AC adapter/charger power cord into AC electrical outlet.
2. Attach the battery to the AC adapter/charger. Align the reference arrow on the battery
with that of AC adapter/charger and push the battery flush with the AC adapter/charger
and slide it in the direction of arrow.
I NOTES:You must remove the DC Cordfrom the AC adapter/charger to charge the batteryi
If the DC cord is connected,
CHARGE
light will flash•
l
3. The "CHARGE"
light will be lit while the battery is accepting
a charge,
and will go out
when the battery is fully charged.
Skillful use of batteries
Use batteries
continuously
until "_"
flashes.
If you use a battery for a short time and
charge it immediately,
the usable time of the battery will be shortened.
NOTES:
1, The time required for charging
the battery is approx, one hour.
2• When fully charged,
the battery should supply approx,
50 minutes of operating
time
3depending
on how much you use zoom and pause).
• Charge the battery before use and store it at normal room temperature.
4• The battery should be charged
at a temperature
of 32°F - 95°F (0°C - 35°C) to prevent
damage.
5• Do not operate the battery at temperatures
below 14°F (-10°C) or above 95°F (35°C).
The battery may be damaged
if operated
at temperatures
above 122°F (50°C), Operation
time will decrease
at extremely
low temperatures.
6• After repeated
chargings
and use. the operation
time will gradually decrease.
When
operation
time becomes too short to be useful, it is time to replace the battery•
7• If the "CHARGE"
and "POWER"
light on the AC adapter/charger
start flashing,
remove
the battery, and then reattach
it, If after several
attempts
both lights continue
to flash, this
means your battery cannot take a charge and must be replaced
with a new one•
Both lights will also flash if a hot battery is attached
to the AC adapter/charger,
Attaching
an
extremely
hot battery to the AC adapter/charger
is not recommended:
it should
be allowed
to cool down before being attached.
8• Do not short the battery's terminal•

Advertisement

Table of Contents
loading

Table of Contents