Box Functions - Hitachi 60FX32B Operating Manual

USING THE VCRPlus+ REMOTE TO CONTROL
CABLE'/SATELLITE BOX FUNCTIONS
Operating the precoded function for your cable/satellite box.
This remoEe is designed to operate different types of cable boxes and satellite systems. You must first program the
remote to match the remote system in your cable/satellite box. (Refer to page 25.)
1. Turn ON your cable/satellite box.
2. Aim the remote control at the front of your cable/satellite box.
Hold down the CABLE button on the remote. After approximately 2 seconds, the message CAB-_ _ will appear
in the remote control display. While still holding down the CABLE button, enter the 2 digit preset code that match-
es your cable/satellite box as shown on page 25. The remote will turn off your cable/satellite box when the cor-
rect 2 digit preset (:ode is entered. When this occurs, the remote control is programmed for your cable/satellite
box. If the cable/satellite box does not turn off after 5 seconds, try a different 2 digit preset code.
The remote will now control your cable/satellite box.
NOTES:
1. If your cable/satellite box cannot be operated
after performing the above procedures, this
means that your cable/satellite box code has not
bee7 precoded into the remote.
2. In the unlikely event that your cable/satellite box
cannot be operated after performing the above
prooedures, please consult your cable/satellite
box operating guide.
3. The remote control will remember the codes you
have programmed in until the batteries are
removed from the remote control. After replac-
ing the batteries repeat the entire programming
procedure stated above.
4. The SLEEP button will act as your cable/satellite
box '100' button if required.
5. The ENTER button will act as your cable/satel-
lite box ENTER button if required.
6. If the CABLE button is pressed and the remote
is already in CABLE mode, the date and day will
be displayed for about 5 seconds. (See page 26
for Remote Control Clock Set procedure.)
7. If the remote has not been programmed for a
cable box and the CABLE button is pressed, the
me.';sage "ERR: SETUP" will be displayed.
CABLE button
This button allows the remote to control your cable
box by setting it to CABLE mode.
PRECODED CABLE/SATELLITE BOX buttons
These buttons transmit the chosen precoded
CABLE/SATELLITE codes.
EXCLUSIVE TV buttons
These buttons are for operating the -IV.
HITACHI
CLU-434VP
PRECODED VCR buttons
These buttons transmit the chosen precoded VCR
codes.
23