Hitachi 60FX32B Operating Manual page 27

JSING THE VCRPlus+ FUNCTIONS
I
1. Look at column 1 of the chart to the right. Compare
the stations in column 1 with those in your local "IV
guide or cable company channel line-up. List all
stations you receive in the blank lines of column 1.
2. In colcmn 2, write in the corresponding VCRPlus+
guide channel codes found in your local TV guide
or cable company channel line-up.
3. In column 3, list the channel number on which you
actually receive each station, according to your
local TV guide or cable company channel line-up.
4. You are now ready to assign your local broadcast
and cable channels to the VCRPlus+ channel
codes.
Press the VCR+ button on the remote control and
the following is displayed:
5. Press the SETUP button on the remote and the fol-
lowing is displayed:
6. Refer to the chart where you have entered numbers
in column 2 and column 3, corresponding to each
local broadcast or cable station. Using the digit but-
tons on the remote, enter the two digit numbers
from column 2 (Guide CH).
7. Press the ENTER button on the remote.
8. Using the digit buttons on the remote, enter the
number from column 3 (IV CH).
9. Press the ENTER button on the remote.
10. Repeat steps 6 through 9 until all rows on your
chart have been completed. (All stations are pro-
grammed.)
11. Repeatedly press the REVIEW button on the
remote to review each entry you have programmed
into the remote. You have reviewed all assigned
station once the following is displayed:
12. If you wish to delete an entry, press REVIEW until
the entry appears, then press the CANCEL button
on the remote one time. Now press the ENTER
button on the remote. The entry has now been
deleted.
13. Once all stations have been assigned and
reviewed, press a remote control mode button (TV,
Cable, or VCR) or ENTER to return the remote to
normal operation.
Column 1
Cableand Broadcast
Stations
(call letters)
Broadcast Stations
ABC
CBS
NBC
FOX
PBS
Column 2
VCRPlus+
Assigned
Channel
(Guide CH)
Column 3
Your Home
Channet
(TV C', H :i
NOTE:
1. Be sure to assign your local broadcast and cable
channels to the VCRPlus+ channel code,'_ or your'
VCR will record a different channel than the oqe you I
intended. If the number in column 2 matches the
number in column 3 (VCRPlus+ guide channel code
and actual TV channel are the same), it is not nec-
essary to set up that channel according to the above
procedure. Also, these stat ons w not be shown
upon REVIEW because they are default settings.
2. You can skip this channel setup for any station you
do not plan to record.
3. Only one -IV channel can be programmecl for each!
VCRPlus+ Guide Channel.
4. If the batteries are removed from the VCP, Plus+
remote control, it may be necessary to rep,_at the
VCRPlus+ Channel Set Up procedure.
27