Table of Contents
Advertisement
USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS
Operating the precoded function for your cable box.
This remote is designed to operate different types of cable boxes. You must first program the remote to match the remote system of
your cable box. (refer to page 37)
1.
Turn ON your cable box.
2.
Aim the remote control at the front of your cable box.
3.
Press and release the Cable (CBL) button to switch to Cable pre-coded mode.
4.
Hold down the CBL button on the remote and enter the two digit preset code that matches your cable box as shown on page 37.
The indicator light will flash 3 times if the code was accepted.
5.
Aim the remote at the cable box and press the POWER button. The remote will turn off your cable box when the correct two digit
preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off,
try a different two digit preset code.
6.
The remote will now control your Cable box.
NOTES:
1.
If your cable box cannot be operated after performing the
above procedures, your cable box code has not been
precoded into the remote.
2.
In the unlikely event that your cable box cannot be
operated after performing the above procedures, please
consult your cable box operating guide.
3.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
4.
The LAST CH button will act as the cable box ENTER
button if required.
5.
The SLEEP button will act as your cable box 100 button
if required.
6.
The INPUT button will act as the TV/SAT button when in
SAT mode.
CABLE (CBL) button
This button allows the remote to control your cable box by
setting it to CABLE mode.
PRECODED CABLE BOX buttons
These buttons transmit the chosen precoded cable codes.
EXCLUSIVE TV buttons
These buttons are for operating the TV.
NOTE:
Refer to instruction manual of the Cable Box for operation of the buttons exclusively for the Cable Box.
TV
DVD
SLEEP
VOL
PIP MODE
PROG
MY CABLE BOX CODE IS:
33
POWER
VCR
CBL
SAT
SOURCE WIZARD
AV1
AV2
AV3
1
2
3
4
5
6
7
8
9
0
LAST CH
HELP
SELECT
CH
INFO
PIP
PIP CH
FREEZE
PIP ACCESS
SWAP
TV/VCR
SLOW
REC
Advertisement
Table of Contents
