Hitachi Ultravision L42S601 Operating Manual page 6

ACCORD ANDPOWER S WIVEL CABLE INSTALLATION INSTRUCTION
The AC cord and power swivel cable p rovided with your n ew LCD Flat Panel Television need t obeinstalled correctly
toavoid t heir d isconnection when r otating the13/on itsTable t op stand.
Located ontheback oftheTVare2 plastic c lamps tohold the ACcord and power swivel cable. Please f ollow
the instructions below.
O
O
O
Pass the AC cord through Clamp #1 and connect
it to the TV. Pull on the clamp to tighten the
AC cord to the TV.
Connect power swivel cable on one end to the
swivel slot of the LCD Rear Panel. Connect
the other end to the swivel slot of the Table
Top Stand Base.
The AC cord, power swivel cable and the signal
cables can all be held together with Clamp #2.
O Clamp #1 : Pass theAC cord through this clamp ;
then pull the clamp to tighten the AC
cord to the TV.
•. 0
O Swivel slot the
LCD back panel.
AC CORD
O Clamp #2: Use this clamp to hold the AC cord, power
swivel connector and the signal cables.
O Swivel on Top
slot Table
Stand Base.