ASSEMBLY
TO ASSEMBLY
BAGGER
(See Figs 6 = 8)
•
Unfold bag and stand right side up.
•
Feed front bagger frame (1) up through fabric loops at
each side of bagger.
•
Snap bottom of front bagger frame (1) into snap feature
at front of bagger bottom.
•
Slide bagger fabric loop (2) segments at the ends of
bag onto top bagger frame tubing.
•
Uninstall two (1\4"-20 x 1.15") hex bolts (3) from the
front of top frame.
•
Reinstall the two (1\4"-20 x 1.15") hex bolts (3) through
holes at top of the front bagger frame and thread into
nuts inside the tubing of top bagger frame.
•
Remove clevis pin (6) and retainer spring (7) from
bagger handle (8).
•
Slide bagger handle (8) down through bagger cover
and frame upper weldment holes.
•
Reinstall clevis pin (6) through hole at bottom of bag-
ger handle and slide retainer spring (7) into hole at
the end of the clevis pin until it locks into place
Fig. 8
TO ADJUST
BAGGER
FULL LEVER/PADDLE
(See Fig 9)
•
Before adjusting, tractor engine must be shut off and
parking brake engaged.
Fig. 6
•
Uninstall (1/4"-20) lock nuts (4) at bottom offront bagger
frame.
•
Unfold cross braces (5) and attach to carriage bolts at
bottom corners of front bagger frame.
•
Reinstall (1/4"-20) lock nuts (4) and tighten until fully
seated.
Fig. 9
•
For the heaviest/wet grasses, remove paddle (3).
•
For lighter grasses use the paddle (3) on setting "1",
"2", or "3" ("3" being for the lightest or dry grass).
•
Choose your setting and rotate the bagger paddle (3)
so that the desired number (setting) faces you.
•
Setting may be changed by loosening fasteners (4 and
5), removing/rotating
paddle (3), and tightening again.
Fig. 7
8