Haier HDB24EA User Manual page 16

Checking w atertemperature
®The minimum incoming temperature must b eat120°F/49°C inorder
forthedetergent todissolve p roperly.
Ifyouareunsure o fthetemperature ofyourhotwater:
1.Open t hehotwater faucet andletitrunforaminute a nd filIaglass.
2.Take a thermometer andcheck thetemperature ofthewater.
3.Ifthetemperature isbelow therecommended 120°F
/ 49°C, then
you need to adjust the water temperature on your water heater in
order to maintain that temperature level.
Overflowing protection
® In case the water level is rising above the highest acceptable point,
the security pressure switch wilI activate the drain pump
automaticaily.
Oycle semection chart
Turn the cycle control knob to the desired cycle. If the door is properly
closed the cycle will start.
Turn the cycle knob to rinse and hold to use this feature. DO NOT
activate the heated dry option while using this feature. Do not use
detergent in this cycle.
Pre-wash _ _ _ _ _ ® ®
pots & _
_ _ _ ® ®
pans
o € € € o
heavywash
o o o o
normal
wash
o
rinse& hold
* Small amounts of water run through the pump to remove soil particles.
® Shows what steps are there in each cycle. Cycle time includes dry time.
Cycle time may be longer depending on the temperature of the water
entering the dishwasher.
Note: Cooler the water, monger the cycle time.
15