Haier HUF138PA User Manual page 11

Reversing the Door (fig. 5 & 6)
This freezer is equipped with a reversible door for left/right opening, ff you prefer
to change the direction of door opening, fallow the steps below:
Note: The freezer comes with the door hinged to the right.
Installing the Door
Shim
Door Pin
fig_ 5
washer
1_ Fix the freezer door
in place
with strong adhesive
tape.
2. Dismantlethe hinge box cover on the top of the freezer door with a Phillips
screwdriverand removethe 2 screwsfrom the hinge. Takeout the hinge by
pulling up vertically. Puttheseaside. (see fig. 5}
3. Removethe adhesivetape on the freezer door, lift and take the door
down.Carefully put it aside_
4_ Removethe door pin from the bracket of the lower hinge by turning it counter
cJockwise_ Move the pin to the opposite hole and tighten_
(see
fig_ 6)
5. Removethe 4 screwsfrom the lower hinge with a Phillipsscrewdriven Remove
thewasher and shim from the right side and install them to the left side_
6. Align the holesin the lower hinge bracket to the correspondingholeson the
opposite sideof the cabinek Insertand tighten screws.
7_ Align the bottom hole on the lower left sideof the door with the pin of the lower
hinge and slide into place.
8. Align the pin of the top hinge with the top hole on the left side of the door and
pushin place. Replacethe screwsin the upper hinge bracket but do not tighten
aJJtheway.
9. Align the door from top to bottomand tighten the 2 screwson the top hinge.
10. Snap on the hinge box coven
11_On somemodelsyou need to screwthe hinge box cover using a phillips screw
driven
10