Haier HVR035 User Manual page 6

1. Remove
all
packaging materiak This includesthe foam baseand a/
adhesive tape homing the wine cellar accessories inside and outside.
2. Inspectand removeany remainsof packing, tape or printed
materialsbefore powering on the wine ce/an
B÷veli g Yoor Wi e C÷ll r
" Your"wine cellar" has three leveling legs
which
are located in the
front and rear corners of your wine ceJlan After properly placing )'our
wine cellar in its final position, you can level your wine ceJJan
Leveling legs can be adiusted by turning them clockwise to raise ),'our
wine cellar or by turning them counterclockwise to lower your wine
ceJJanThe wine ce/ar door wiJJdose easier when the Jevding legs are
extended.
® After leveling legs are adjusted, the door support also needs to be
adjusted to floor level.
Iroler Air Qir¢ IQtio
® To assure your wine cellar works at the maximum efficiency it was
designed for, you should instal it in a location where there is proper air
circulation, plumbing and dectricaJ connections.
The following are recommended clearances around the wine cellar:
Sides ............... 2_ (50ram)
Top.................... 2= (50ram)
Back.................. 2_ (50ram}
® Do not over fiJJyour wine cellar for proper wine cooling.
Note: If your wine cellar has been tiled for any reason,wait 24 hours
before plugging it in.