Advertisement
iNSTALL
SEAT (See Fig. 3)
Seat positbn should be adjusted forward or backward so
that the operator can comfortaMy reach dutch/brake pedal
and safely operate the tractor,
o
Remove the two (2) bolts and fiat washers securing
the seat to cardboard packing, Keep the two (2) bolts
only and place them with the two (2) identical bolts
and four (4) washers in the parts bag, Discard the fiat
washers and cardboard packing,
o
Rebase L,H, seat slide on seat pan by pulling out on
adjustment handb and sliding it to the rear positbn
exposing seat mounting hobs from bottom, SHde R,H,
slide to same rear positbn,
*
Mount rear of seat on slides using mounting bolts and
bck washers as shown,
*
Pull out on adjustment handb and slide seat aHthe way
forward, Install front mounting bolts and lock washers,
Tighten all mounting bolts securely,
o
Lower seat into operating position and sit on seat, Press
clutch/brake pedal all the way down, If operating posi-
tion is not comfortable, adjust seat,
*
To adjust seat: Grasp adjustment handle and pull out,
slide seat to desired position and release adjustment
handle,
ADJUSTMENT
L.H. SEAT
SU[
SEAT
MOUNTmNG
BOLTS
FmG° 3
TO ROLL TRACTOR
OFF SKmD (See Op-
eration
section
for _ocation
and function
of
controJs}
o
Press lift lever plunger and raise attachment lift lever
to its highest position,
o
Release parking brake by depressing brake pedal,
o
Place freewheel control in "transmission disengaged
position" (See "TO TRANSPORT"
in the Operation
section of this manual),
*
Roll tractor forward off skid,
TO DRIVE
TRACTOR
OFF
SKID
(See
Op-
eration
section
for _ocation
and function
of
controls}
,_kWARNING: Before starting, read, understand and follow
all instructions in the Operation section of this manual, Be
sure tractor is in a welPventilated area, Be sure the area in
front of tractor is clear of other people and objects,
o
Be sure all the above assembly steps have been com-
pbted,
*
Check engine oil level and fill fuel tank with gasoline,
o
Place freewheel control in "transmission
engaged"
position (see "TO TRANSPORT" in Operation section
of this manual),
*
Sit on seat in operating position, depress brake pedal
and set the parking brake,
*
Place motion control lever in neutral (N) position,
*
Press lift lever plunger and raise attachment lift lever
to its highest position,
*
Start the engine,After engine has started, move throttb
*
Release parking brake,
*
Slowly move the motion control lever forward and slowly
drive tractor off skid,
o
Apply brake to stop tractor, set parking brake and place
motion control lever in neutral position,
o
Turn ignition key to "STOP" position,
Continue with the instructions that follow,
Advertisement
