Advertisement
SERVICE AND ADJUSTMENTS
BOTH FRONT PLATE LINKS MUST BE
EQUAL iN LENGTH
NUT"D"
NUT"C"
FRONT PLA!E
I.o_
,_
_
ASSEMBLY
FHG.22
TO REPLACE
MOWER
DRIVE BELT
MOWER DRIVE BELT REMOVAL (See Fig, 23)
o
Park tractor
on a level surface,
Engage
parking
brake,
o
Lower mower to its lowest position,
o
Disengage belt tention rod from lock bracket,
A
o
Remove screws from R,H, mandrel cover and remove
cover,
o
Remove any dirt or grass clippings which may have
accumulated around mandreb and entire upper deck
surface,
Disconnect R,H, suspension arm from rear deck bracket
by removing retainer spring,
Roll belt over the top of R,H, mandrel pulby carefully,
o
Remove belt from electric clutch pulley,
o
Remove belt from idler pulleys,
idler arm and two idlers to see that they
rotate freely,
Be sure spring is securely hooked to primary idler arm
and spring arm,
MOWER DRIVE BELT INSTALLATION (See Fig, 23)
o
Install belt in both idlers,
Install new belt onto electric clutch pulby,
Roll belt into upper groove of R,H, mandrel pulley care°
fully,
•
Carefully check belt routing making sure belt is in the
grooves correctly,
•
Reconnect R,H, suspension arm to rear deck bracket
with retainer spring,
•
Reassemble R,H, mandrel cover,
o
Engage belt tension rod by pushing rod into locking
bracket,
IDLED
FmG. 23
TO REPLACE
MOWER BLADE (SECONDARY}
DRIVE BELT (See Fig. 24}
Park the tractor on level surface, Engage parking brake,
Remove mower (See "TO REMOVE MOWER" in this
section of manual),
o
Remove screws from R,H, and L,H, mandrel covers
and remove covers,
REMOVE MOWER DRIVE BELT
(Refer to "TO REMOVE MOWER DRIVE BELT" illustration
in this section of manual),
o
Carefully roll belt over the top of R,H, mandrel pulley,
o
Remove belt from idler pulleys,
o
Check primary idler arm and two idlers to see that they
rotate freely,
o
Be sure spring is securely hooked to primary idler arm
and spring arm,
REMOVE MOWER BLADE (SECONDARY) DRIVE BELT
o
Carefully roll belt off L,H, mandrel pulley,
Remove belt from center mandrel pulley, idler pulley,
and R,H, mandrel pulley,
Remove anydirt or grass which may have accumulated
around mandrels and entire upper deck surface,
Check secondary idler arm and idler pulley to see that
they rotate freely,
Be sure spring is hooked in secondary idler arm and
secondary spring arm,
iNSTALL NEW MOWER BLADE (SECONDARY)
DRIVE
BELT
Install new belt in lower groove of R, H, mandrel pulley,
idler pulley, and center mandrel pulley as shown,
Carefully roll belt over L,H, mandrel pulley, Make sure
belt is in all grooves properly,
REINSTALL MOWER DRIVE BELT
(Refer to "TO REMOVE MOWER DRIVE BELT" illustration
in this section of manual),
o
Install belt into upper groove of R,H, mandrel pulley
and around both idlers, Pull belt to front of mower to
remove slack,
23
Advertisement
