Download Print this page

Husqvarna GTH2548B Owner's Manual page 29

917.279040

Advertisement

G
PROBLEM
Will not start
Hard to start
Engine will not turn over
Engine cricks but will not
start
Loss of power
Excessive
vibration
CAUSE
1.
Out of fuel.
2.
Engine not"CHOKED"
properly.
3= Engine flooded.
4.
Bad spark plug.
5.
Dirty air filter.
6= Dirty fuel filter.
7= Water in fuel=
8.
Loose or damaged wiring.
9.
Carburetor out of adjustment.
10= Engine valves out of adiustment=
11.
Extreme cold conditions.
1.
Dirty air filter.
2= Bad spark plug.
3= Weak or dead battery.
4= Dirty fuel filter.
5= Stale or dirty fuel.
6= Loose or damaged wiring.
7= Carburetor out of adjustment.
8.
Engine valves out of adjustment.
1= Brake pedal not depressed.
2.
Attachment clutch is engaged.
3.
Weak or dead battery.
4.
Blown fuse.
5.
Corroded battery terminals.
6.
Loose or damaged wiring.
7.
Faulty ignition switch.
8.
Faulty solenoid or starter.
9.
Faulty operator presence switch(es).
1.
Weak or dead battery.
2.
Corroded battery terminals.
3.
Loose or damaged wiring.
4.
Faulty solenoid or starter.
1.
Cutting too much grass/too fast.
2.
Throttle in"CHOKE"
position.
3.
Build-up of grass, leaves and trash under mower.
4.
Dirty air filter.
5.
Low oi! level/dirty oil.
6.
Faulty spark plug.
7.
Dirty fuel filter.
8.
Stale or dirty fuel.
9.
Water in fuel.
10.
Spark plug wire loose.
11.
Dirty engine air screen/fins.
12.
Dirty/clogged
muffler.
13.
Loose or damaged wiring.
14.
Carburetor out of adjustment.
15.
Engine valves out of adjustment.
1.
Worn, bent or loose blade.
2.
Bent blade mandrel.
3.
Loose/damaged
part(s).
CORRECTION
1= Fill fuel tank.
2.
See "TO START ENGINE" in Operation section.
3.
Wait several minutes before attempting to start.
4.
Replace spark plug.
5.
Clean/replace
air filter.
6.
Replace fuel filter.
7.
Empty fuel tank and carburetor, refill tank with fresh
gasoline and replace fue! filter.
8.
Check all wiring.
9.
See "To Adjust Carburetor" in Service Adiustments
section.
10.
Contact an authorized service center/department.
11.
See "To start engine" in operation section
1= Clean/replace
air filter.
2.
Replace spark plug.
3.
Recharge or replace battery.
4.
Replace fuel filter.
5.
Empty fuel tank and refill tank with fresh, clean gasoline.
6.
Check all wiring.
7.
See "To Adjust Carburetor" in Service Adiustments
section.
8.
Contact an authorized service center/departmenL
1= Depress brake peda!.
2.
Disengage attachment
clutch.
3.
Recharge or replace battery.
4.
Replace fuse.
5.
Clean battery terminals.
6.
Check all wiring.
7.
ChecWreplace
ignition switch.
8.
Check/replace
solenoid or starter.
9.
Contact an authorized service center/departmenL
1= Recharge or replace battery.
2.
Clean battery terminals.
3.
Check all wiring.
4.
ChecWreplace
solenoid or starter.
1= Raise cutting height/reduce
speed.
2.
Adiust throttle control.
3.
Clean underside of mower housing.
4.
Clean/replace
air filter.
5.
Check oi! level/change oil.
6.
Clean and regap or change spark plug.
7.
Replace fuel filter.
8.
Empty fuel tank and refill tank with fresh, clean gasoline.
9.
Empty fuel tank and carburetor, refill tank with fresh
gasoline and replace fuel filter.
10.
Connect and tighten spark plug wire.
11.
Clean engine air screen/fins.
12.
Clean/replace
muffler.
13.
Check all wiring.
14.
See "To Adjust Carburetor" in Service Adjustments
section.
15.
Contact an authorized service center/department.
1= Replace blade. Tighten blade bolt.
2.
Replace blade mandrel.
3.
Tighten loose part(s).
Replace damaged parts.
29

Advertisement

loading

This manual is also suitable for:

91.279040