Husqvarna GTH2548B Owner's Manual page 27

SERVICE AND ADJUSTMENTS
TO REPLACE HEADMGHT BULB
• Raise hood,
o Pull buUbhoUder out of the hoUein the backside of the
grHL
• RepUace buUbin hoUderand push buUbhoUder secureUy
back into the hoUein the backside of the grill
• CUosehood,
mNTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorUy,stop running, or prevent it from starting,
o Check wiring, See eUectricaUwiring diagram in the
Repair Parts section of this manual
TO REPLACE FUSE
RepUace with 30 amp automotive-type pUug=infuse, The
fuse hoUderis Uocated behind the dash,
HOOD
HEADUGHT
WIRE
CONNECTOR
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 3t}
• Raise hood,
• Unsnap headlight wire connector,
• Stand in front of tractor, Grasp hood at sides, tilt toward
engine and lift off of tractor,
• To replace, reverse above procedure,
FIG. 31
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and
adjustment should not be necessary, if adjustment is nec-
essary, see engine manual,
TO ADJUST CHOKE CONTROL
The choke control has been preset at the factory and ad=
justment should not be necessary, If adjustment is neces-
sary, see engne manual,
TO ADJUST CARBURETOR
Your carburetor is not adjustable, If your engine does not
operate properly due to suspected carburetor problems,
take your tractor to an authorized service center for repair
27