Icemaker Accessory Kit - Hotpoint HSS25GFTHWW Owner's Manual And Installation Instructions

About the automatic icemaker.
]t is mmnal for sexeral cubes to be ioined tooether
If ice is not used fl'equenfly, old ice cubes will
become chmdy, taste stale, and sl/fink.
Icemaker Accessory Kit
If your refi_igerator did not come ah'eady
e(iuipped with an automatic icemake_; an
icemaker accesso_ y kit is a\zfilable at extra cost.
Check tile back of the refrigerator for tile specific
icemaker kit needed fi)r your model.
About the ice and water dispenser.(o,so,,o ,,oao¢s )
Spill Shelf
ToUse the Dispenser
® @ •
Select _wQt._ _rushed _ or _cubed_
Press tile _olass _oenfl_, against, tile top of tile
dispenser
cradle.
Tile spill sheff is not self-draining. To
reduce water Sl)Otting,, tile shelf and its
grille should be cleaned regularly:
Locking the Dispenser (on somemodels)
@ Pres_ tile
Lock
pad
k_ for 3 sec°I,ds t° l°ck the
LO¢ dispenser and control panel.
To tmlock, press and hold
Hold 3 seconds the pad again for 3 seconds.
If no water is dispensed when therefrigeratoris
first installed,theremaybe air in the water line
system.Pressthedispenserarmfor at least two
minutestoremovetrappedair from the waterhne
and to fill the watersystem.Toflushout impurities
in the waterline, throwaway thefirst sixg/assfuls
of water
CAUTION: Never put fingers or any other
objects into the ice crusher discharge opening.
Dispenser Light
Q This
pad rams
tile nightlight
_____L "x in tile dispenser on and off.
ightJ Tile light also comes on when
the dispenser cradle is prmsed.
If this light bums out, it shotfld
be rq)laced _fith a 6 _tt
ma_mum, 12 volt D(: btflb.
Ice Storage Drawer on Dispenser Models
To remove:
Slide tile icemaker power switch to the OFFposition.
Ptdl the drawer straight out and then lift past the stop
l)_sifion.
Toreplace:
\._lwn replacing the (h'awel; make sure to push it
fimdv into place. ]f it does not go :111the way back,
reino\'e it and rotate the drive mechanism 1/4 turn.
Then lmsh the drawer back again.
Mechanism
Important Facts About Your Dispenser
Yi:: Do not add ice fl'om trays or bags to tile storage bin. It
may not crush or dispeI{se well.
i;_? A void overfilling glass with ice and use of narrow glasses.
Backed-up ice can jam tile chute or cause tile door in tile
chute to freeze shut. If ice is blocking the chute, poke it
through with a wooden spoon.
i;_? B everages and fl)ods should not be quick-chilled in the
ice storage bin. Cans, bottles or fl)od packages in tile
storage bin may cause the icemaker or auger to jam.
i;_? T o kee I) dispensed ice fl'om missing tile glass, put tile
glass close to, but not touching, tile dispenser opening.
8
>_Some crushed ice may be dispensed even though you
selected Cubed. This hal)pens oc(-asionallv when a fray
cubes haxe been left in tile crushe_:
>_ _Mter crushed ice is dispensed, some water may drip from
tile chute.
i;_? S ometimes a small motmd of snow will titan on tile door
in the ice chute, This condition is nomml and usually
()cctu_ when you have dispensed crushed ice repeatedly:
Tile snow will eventually e\:q)orate.
i;_;: Tile fi_st glass of water dispensed may be wam/er than
tile fi)llowing ones. This is nomml.
>: Dispensed water is not ice cold. For colder water; simply
add crushed ice or cubes before dispensing water: