Automatic Icemaker - Hotpoint 25 Owner's Manual And Installation Instructions

About the automatic icemaker.
A newly-installed refrigerator may take 12–24 hours to begin making ice.
Power
Switch
Icemaker
Green
Power Light Feeler Arm

Automatic Icemaker

(on some models)
The icemaker will produce seven cubes
per cycle—approximately 100–130 cubes
in a 24-hour period, depending on freezer
compartment temperature, room
temperature, number of door openings
and other use conditions.
If the refrigerator is operated before the
water connection is made to the icemaker,
set the power switch in the OFF position.
When the refrigerator has been connected
to the water supply, set the power switch to
the ON position.
The icemaker will fill with water when it cools
to freezing. A newly-installed refrigerator may
take 12 to 24 hours to begin making ice
cubes.
Throw away the first few batches of ice to
allow the water line to clear.
Ice Storage Drawer
To access ice, pull the drawer out.
To remove the drawer, pull it straight out
and lift it past the stop location.
Icemaker Accessory Kit
If your refrigerator did not come already
equipped with an automatic icemaker,
an icemaker accessory kit is available at
extra cost.
www.Hotpoint.com
Be sure nothing interferes with the sweep of
the feeler arm.
It is normal for several cubes to be joined
together.
If ice is not used frequently, old ice cubes
will become cloudy, taste stale, and shrink.
If the ice cubes become stuck in the
icemaker, turn off the icemaker, remove
cubes and turn icemaker back on.
There is an upper freezer shelf
above the icemaker that can be
used for storage.
Check the back of the refrigerator for
the specific icemaker kit needed for
your model.
9