GE Monogram Refrigerator Owner's Manual page 8

Ice & Water Dispenser (on
some models)
Built-In Refrigerators
Ice storage
bin
To remove:
I,iff up the access door to reach the icemaker.
Set the icemaker power switch to the O (off)
position. With the access door closed, support
the storage bin at the bottom while slighdy
lifting. Pull bin suaight out.
AccessD_
To replace:
Slide the bin back until the mb oi1 the bill
locks into the slot on the shelf. If the bin
does not go all the way back, remove it and
rotate the drive mechalfisnl 1/4 unn. Then
push the bin back again.
Rotate
Drive
Mechanism
Important
facts about
your ice
& water
dispenser
Do not add ice fiom trays or bags to the
storage bin. It may not crush or dispense well.
Avoid overfilling glass with ice and use of
narrow or extra-tall glasses. Backed-up ice
call jam the chute or cause the door ill the
chute to fleeze shut. If ice is blocking the
chute, poke it through with a wooden spoon.
Beverages and foods should not be
quick-chilled in the ice storage bin.
Cans, bottles oa food packages ill the
storage bill may cause the icemaker
or auger to jam.
To keep dispensed ice flom missing
the glass, put the glass close to, but not
touching, the dispenser opening.
Some crushed ice may be dispensed even
though you selected CUBES. This happens
occasionally when a few cubes accidentally
get directed to the crushei.
AtYer crushed ice is dispensed, some water
may drip flom the chute.
Sometimes a mound of snow will form on
the door ill the ice chute. This condition is
normal and usually occurs when you have
dispensed crushed ice repeatedly. The snow
will eventually evaporate.
Dispensed water is not ice cold. For colder
water, simply add crushed ice or cubes
before dispensing wateL
The first glass of water dispensed may be
warmer than the following ones. This is
noItllal.
To eliminate drips on the spill shelf, tilt the
glass in slightly when dispensing wateL