7 pe I bulb
replacement
NOTE: Before replacing
tim bulbs, review
the light bulb information
and X_SkRNING
on page 18.
Replacing
Type 1 bulbs located
in lamps
behind
the top pan in the fresh
food
compartment
and the bottom
freezer
basket
in the freezer
compartment:
1°
°
Disconnect
power at tim circuit breaker
or fllse box and allow the lamps to cool.
To access
the lamps
in the flesh
food
compartment,
remove
tim top pan.
See Drawer and Pan Removal section.
To access
the lamps
in the fleezer
compartment,
remove
tim bottom
fleezer
basket.
See b)'_ezer Baskets section.
3°
4°
On the back wall there is a curved light
shield. Grasp each end of the light shield.
Pull the shield toward you and the robs
on the shield will release flom the slots in
the housing.
Remove
tim glass above
tim bulbs
by pulling
it straight
out.
NOTE: Always follow bulb manufacturer's
directions
for handling
and replacing
bulbs.
5. Remove the bulb by holding
tim base and
pulling suaight
up. Replace with a new bulb.
6. Replace the glass by sliding it into place.
Then replace the light shield by resting the
top lip of the shield on top of the light
housing. Then press tim sides until tim robs
pop into the slots in the housing.
WARNIN G:
The light shield must
be replaced
or tim heat flom tim bulb could
damage the refligeratoL
7. Reset the circuit
breaker
or fuse box.
19
Need help?
Do you have a question about the Monogram Refrigerator and is the answer not in the manual?
Questions and answers