GE ASW10 Owner's Manual & Installation Instructions page 5

go.tom
Additional controls and important information.
Do Not Operate in Freezing Outdoor Conditions
This (eel<rely air (onditioner was not dcsign(+(l tbr
fl-eezing outdoor con(litions. It must not be used ill
fl-eezing outdoor conditions.
When the air conditioner is turned on, it wil!
automatically start in the setting last used,
Power Outage Recovery Feature
In the _ase of a power Otltage or interruption, the Sleepfbamres will res(t 1o tile original selling.
unit will amomaticall} re_mrt in tile s(tfing_ last You may n(ed to s(t a new time if desil>d.
used after the power is restored. The Timerand
Cool Mode
tse tile Cool mode with High (3),Mud (2)or
Low (1)fSmfk_rcooling. Lse lhe Increase • /
Decrease• pads 1o set the desired temperature
between 64°F and 86°F in l °F increlnents.
A thermostat is used to mailmlin tile room
tempet-,mn-e. The conlpressor will (3cle on and off
to kee l) the room at tile set level of (x)mfi_rt. Set the
thermostat at a lower mnnber and tl_e indoor air
will become coolel; Set tile thermostat at a higher
number and the indoor air will be(ome wannel;
NOTE:If the air conditioner is off and is then turned on
wlfite set to Cool,it wilt take approximately3 minutes for
the compressorto start and cooling to beghT.
Cooling Descriptions
For Normal Coo/ing--Sde(t Ill( Cool mo(le
mM High (3) or Med (2) fim with a middle set
tempel-_tu re.
For Maximum Cooling--Select tile Cool mode
mM High (3) tim with a lower s(,t temperature.
For Quieter & Nighttime Coolinff--Select th(
Cool mode mid Low (1) f_m with _ lni(/dlt" s('t
telllpel-Htll l-e.
NOTE"If you switch from a Cool setting to Off or to
a fan setting wait at least 3 mh?utes before switching
back to a Cool setting.
Fan Mode
I sc the Fan at High (3), Med (2) or Low (1) to provide Sinre t;m only st'ldngs do not l)rOxi(/e (ooling,
air cir(ulafion an(I filtering without cooling, a telnpemture setting will not be displayed.
Vent Control (on some models)
The vent control is localt'd on the inside of the
air louv( p+in file lower right (orn(t;
When set at CLOSE, only tile air inside the room
will be circulated and conditioned. When set at
OPEN, some insi& air is exhausted outside.
I I
Toopenthe vent`pushthe leverto the Toopenthe vent,pushtl?e
right Toclosei_,pushft re ftTeleft leverto the right. Toclose
i_,pushft re the left
Air Direction--Up and Down (on some models)
FingvJtip pressure on the horizontal louvers a({justs
the air dir(cfion up or down.
Air Direction--Side-to-Side (onsomemodels)
On some models, tilt' si(le-t<>si(/e air dire(tion is
a(ljusted b} the louxer h,xers or by grasping mid
lnoving file inner veltical louvers.
5