Energy Saving Tips; Lubrication - Hoover innovation U4231 Owner's Manual

4. On the opposite end, pry off
end section of agitator roll, using
a screwdriver.
DISPOSABLE AGITATOR ROLL SLEEVE END SECTION
SQUARE r_ ,.llllllllll 4 l_ _'e'e'_ ROUNO
i BEARING _ '" BE,_"Hi'iG
' WASHE 7"
" WASHER SHAFT PLAST C g_.P ' END
END PLASTIC CUP. FELT ',', _' $ _' E R PLATE
PLATE FELT WASHER
5. Replace parts onto new
agitator roll sleeve.
Note: Be sure that end plate with
flat-sided projection is screwed
onto belt end of agitator roll.
6. Reinstall agitator into cleaner.
7. Replace bottom plate I see step
10 and drawing at top of
preceding page).
Lubrication
The motor is equipped with two ball bearings which contain sufficient
lubrication for the life of the motor. The addition of lubricant could cause
damage. Therefore, do not add lubricant to either motor bearing.
The agitator is equipped with two ball bearings that should be '_ubricated
periodically by a Hoover Factory Service Center or an Autho, zed Hoover
Warranty Service Dealer.
Energy saving tips
1. Replace throw away bag promptly, before overfilled. Use a genuine
HOOVER bag made for your model cleaner.
2. To maintain effective cleaning, replace agitator roll sleeve and belts
when necessary.
3. Turn off cleaner when not in use, such as when moving furniture.
4. Keep your cleaner operating at peak performance level - have
inspection and service performed by a Hoover Factory Service Center
or Authorized Hoover Warranty Service Dealer.
18