Hoover Convrtible U4109 Owner's Manual page 18

How to replacethe brushes
Disconnect the deaner from electrical outlet.
1. To replace worn brushes, remove bottom plate, belt and agitator, following
directions given on preceding pages.
iND PLATES
2. Turn end plates of agitator
counterclockwise until one end
plate comes off.
3. Then pry out end section as
shown.
4. Remove opposite end plate and
shaft by pulling straight out. Pry
out remaining end section.
5. Remove brushes by pulling them
from agitator. Use pliers if necessary
Slide new brushes into channels.
Push them in as far as possible.
END SECTION
WASH E R
BEARING
LOCATOR
6. To reassemble, reverse procedure.
Replace first, the last end section
removed, then end plate and shaft.
Replace remaining end section and
end plate. Be sure end sections are
assembled with Iocator lined up
with slot in agitator.
7. Should you accidentally displace
the bearing during disassembly,
reassemble as shown.
17