Cleaning Tools - Hoover WindTunnel U6434900 Owner's Manual

AUTOMATIC
BRUSH ROLL
( )
ON OFF
OFF when cleaning bare floors.
Automatic brush roll
indicator (some m ode_s
only)
When red is in the OFF window, brush
roll is STOPPED.
When red is in the ON window brush roll
is ROTATING.
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the front of clean-
er as shown and will prevent rug from
clinging to cleaner.
Continue to lift front of cleaner so that
when you have reached the edge, it is
completely off the rug. Move cleaner
back to start again, lower front of cleaner,
and use only forward strokes.
Edge cleaning
Special edge groomers are provided
on both sides of the front of the cleaner
to remove dirt in carpet near base-
boards and furniture.
Guide either side parallel to the edge of
C
_l,_oPetor furniture. •
W 110azzacn tool
cover
The tool cover is designed with a
"break-away" feature which allows it to
snap free if it is pushed open too far.
To reattach, align hinges of cover with
slots on sides of tool storage area.
Push cover down to secure in place.
How to clean tools
To clean the hose, wipe off dirt with a
cloth dampened in a mild detergent.
Rinse with a damp cloth.
Cleaning tools may be washed in warm
water with a detergent. Rinse and air
dry before using.
Cleaning tools
When using cleaning tools, cleaner
handle should be in the upright posi-
tion to activate the automatic "brush
roll OFF" and for convenience in
moving the cleaner from one area to
another.
Turn cleaner OFF before disconnect-
ing and connecting hose to hose tube
(A).
To use hose, lift hose end as shown.
Stair Cleaning
You may use the hose and furniture noz-
zle for stair cleaning.
CAUTION: To prevent the cleaner
from falling, always place it at the
bottom of the stairs.
With handle in upright position, clean
from bottom to top.
Attach wand and
tools
Attach tool or wand to the hose (B) by
pushing it firmly into hose.
Attach second wand or tool to wand (C)
by pushing it firmly onto the wand.
Twist wand or tool slightly to tighten or
loosen the connection.