Advertisement
Basic operations
To project 1
1
,
5 7 4 2
m
5_
_7
/4
1
Turn on the main power switch of the projector [ I: ON].
• The ON indicator
will light orange.
2
Press the STANDBY / ON button.
• The ON indicator
will blink green and then light green.
• The green blinking indicates
warmup.
• After the power is turned on, the lamp will be cooled for approximately
1 rain. and the power cannot
be turned on even by pressing the STANDBYJON
button.
3
Remove the lens cap.
4
Use the ZOOM button to adjust the screen size.
5
Use the FOCUS button to adjust the focus.
(1) The display shown to the right will appear when the FOCUS button is pressed.
(2) Use the FOCUS button to adjust the focus until the image is sharp.
(3) The message "Focus" will disappear if any other button is pressed.
+++FOCUS+++
6
Turn on the power to the connected equipment.
Refer to page 31 concerning
the connection
of other equipment.
7
Press
either
the
INPUT
button
of the
projector
or the VIDEO/RGB
button
of the
remote
control
to select
the signal
to be
projected on the screen.
The selected signal input channel will be displayed in the lower right part of the screen.
Exampleon-screendisplay
RGB 1
13
Advertisement
