Tips On Rear Panel Connections - Hitachi 51M200A Operating Manual

TIPS ON REAR PANEL CONNECTIONS
iiiiiiiiiiii ii iiiii!iiiiiiiiiil
iiiiiiiiiiii i!:ili!iiiii!i!i
S-VtDEO and DVI-HDTV connections are provided for high performance laserdisc players, VCRs etc. that have this feature. Use
these connections in place of the standard video connection if your device has this feature.
If your device has only one audio output (mono sound), connect it to the left audio jack on the Projection Monitor.
Refer to the operating guide of your other electronic equipment for additional information on connecting your cables.
You may use VIDEO or S-VIDEO inputs to connect to Input 3, Input 4 or Input 5, but only one of these may be used at a time.
Connect only 1 component (VCR, DVD player, camcorder, etc.) to each input jack.
COMPONENT: Y-PBPR (Input 1 & 2) connections are provided for high performance components, such as DVD players and
set-top-boxes. Use these connections in place of the standard video connection if your device has this feature. Input 2 accepts
both composite or component video signals.
Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the Monitor's PB
input and the components R-Y output to the Monitor's PR input.
Your component outputs may be labeled Y-CBC R. In this case, connect the components C B output to the Monitor's PB input
and the components C R output to the Monitor's PR input.
You may use composite video signal for Input 2~Input 5.
tt may be necessary to adjust TINT to obtain optimum picture quality when using the Y-PBPR inputs (see page 34).
To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the Y-PBPR jacks.
When using a DVl input from a Set-Top-Box, it is recommended that a 1080i or 720p input signal is used.
12