Table of Contents
Advertisement
VCR FUNCTION
SETTING
You can change the VCR mode as required using
the "INTELASCAN
GUIDE MENU".
•
REMOTE
MODE VCRI/VCR2
POWER
button--
GUIDE
button_
VCR1 burton
--VCR2 button
-"t" - ",,"
_,_, _.,_-
buttons
-_...'_
____....
_'_
Press "'4 "° ,,I.
to change
VCR 1: Normally select this "VCRI".
VCR 2: Select "VCR2"
when you are using
another Hitachi VCR and operate the
two VCRs using the remote control
unit provided with this VCR.
Note:
After you have selected "VCR2",
press the VCR2 button and then perform the
following operations; otherwise, the VCR
does not accept commands.
To return to .
"VCRI"
after you have selected "VCR2",
press the VCR2 button first.
1. "Turn on the power of both the VCR and TV.
2. Be sure that the TV is set to the video channel
(3 or 4).
3. Point the remote control unit at the receiver on
the front panel of the VCR.
4. Press the GUIDE button until the "menu",
as
illustrated, will appear on the TV screen.
•
MOVIE
RETURN
ON/OFF
Press "5"
"_
to change
5. Press button "1".
ON:
When a cassette (with erase prevention
tab removed) is loaded, playback starts
automatically.
When the tape reaches •
the end, it will stop automatically and will
rewind to its start. Then the cassette will
be ejected automatically.
Note:
This function also rewinds the tape
automatically when it detects a non-
recorded sectionlasting about 30 seconds
or more.
OFF: This function does not operate.
•
The VCR function
set menu will appear.
Press buttons "4" through "8" to se(ect the
required function.
E22
Advertisement
Table of Contents
