Troubleshooting - GE AZ75W18DACM1 Owner's Manual And Installation Instructions

BeforeYouCallForService... ge.com
Troubleshooting tips
Problem Possible Causes What ToDo
Zoneline does The unit is
• Mak(' su re lh(' Z{melinc plug is ])ushe(1 completely
notstart
unpluKge& into th( oullet.
The fuse is blown/circuit • Check tile house fuse/cir(uit/)l>aker l)ox and replace
breaker is tripped, the tilS( or r(s(t the br(ak(r.
The unit is u_aiting for • This is normal. The Zoneline will start again afler
the compressor overload it rt'sels.
protector to reset.
Power failure. • There is a prolective time delay (up to 3 nlinums) to
l)rcvent tripping of the compressor overload. For this
reason, the unit may llOt Sml-t normal heating or cooling
t_lr 3 lninutes aiier it is Hn-ned back o11.
Zoneline does not cool Indoor airflow • Make sure there arc no curtains, l)linds or furnimru
or heat as it should is restricted, blocking the air d ischmge glille or the return air grille.
Outdoor airflow is • Make suru the art hitectuml louver is not rustricm(I.
restricted or recirculated. This call Catlse the unit to (wcle ofldue to th_
COllll)l'eb_,or ox erloa(I.
• ()utdoor grille must have a minimum of 65% tree area.
Non-GE grilles may be 1oo restlictive tbr proper
l)erlbrmanc(. Consult }our salesperson fbr assismnc(.
The air filter is dirt)< • Chang( lhe tilmr at least (xelw 30 (lays.
See th{ Care and Cleaning-Air Filter section.
The room mayhave • When th( Zoneline is tiler turned on 3ou need to
been hot or cold. allow lime for the room to cool down or walm Ul).
Outdoor air is '* Set th( vent conwt)l to tile CLOSE position.
entering the room.
Burning odorat the start Dust is on the surface • This can cause a "l)urning" odor at the beginning ot
of heating operation
of the heating element, the heating operation. This o(Ior should quickly fh(l(.
The air is not always The heat pump is not * This is nornml. The heat pllmp will produce warm air
cool or hot during
prothmh N hot air. but not as hot as air produced when the higher-cost
operation
elecuic heat is used.
The fan switdz may be • This cruises th( t_m to blow room temperature air
set at continuous fan even when the compressor or heater cycles off.
'1'11{
(OlllilIIIOIlS air lllOV( i1](_111
provides
b(ller
or( ralI temperatllre COlltrol.
The aft"does not feel
warm enough during
heating operation
The heat pump alone
produces air that feels
cooler than desired.
• Lse the Electric Heat Option. This t!lrlls off the
heat pump an(I warms with electric heat only.
NOTE: Use of this option will result in #Tcreasedenergy
CORSUmptioR
23