GE AZ75W18DACM1 Owner's Manual And Installation Instructions page 21

Installation Instructions
[] MAKE UNIT ELECTRICAL
CONNECTIONS
1.
Conne(t tile thermostat wires to tile unit and s(t
the dip switches to the appropriate seuings.
NOTE: See tile Controls-Terminal Connections
and Controls-Dip Switches se(tions ot this
mmmal and the mmmal with th( separate
thermostat for prtq)er connections
and settings.
[_
Thermostat
I
Maximum Wiring
Length for Thermostat
Connection to the Unit
66 ft. for AWG 18
60 ft, for AWG 20
40 ft. for AWG 24
AW6 American W ire
6auge
Unit Connections
2. Make po_er connections to the unit.
NOTE: Se_ d_e ELECTRICALREQUIREMENTS at_d
DIRECTCONNECTAPPLICATIONS set dons,
as appropriatc, of this lnalltlal [_)1-pl-o[)el-
colmections.
3, Replace the case h-ont panel by replacing the [bur
hxIllt SCl'ews atld the two to[) scFews.
7_ CONNECT THE TOP DUCT
1.
Install lhe du(l onto th( air disdlarge outlet.
0,g, .................. il
ductwork
Flexibleor rigid
ductwork
Air /
discharge
outlet
2. Secure
the t_ l) duct to the trait b} turning the four
case top duct av!justing screws until lht T are tight.
[sea field suppli< d clamp to lock th< top duct to
the cas(.
duct adjusting
screws
21