Touch Pad Models - GE AGM06 Owner's Manual And Installation Instructions

Aboutthe controlsontheair conditioner odels with touchpads.
Features and appearance will varg.
0
0
FAN$PI£ED
"nlIER MOOE
B_
0
0
0
Air ConditionerControls
RemoteControl
Controls
) ON/OFFPad
G Turns air conditioner on and off.
@ Display
Shows the set temperature or time remaining
on timer.
Gi MODE
F Use to set the air conditioner to COOL or
FANmode.
Gh Increase •/Decrease • Pads
r Use to set temperature when in COOL mode.
) FANPad
_
Use to set the fan speed to LOW(F1),MED(F2)
or HIGH(F3).
O ENERGYSAVER (on some models)
Controls the fan.
ON-The fhn and compressor cycle on and off
This results in wider variations of room
temperature and humidib: Normally" used
when the room is unoccupied.
Note: The fan
will continue to run for a short time after the
compressor cycles off.
0FF-The fan runs all the dme, while dm
compressor cycles on and off.
_illis feature must be set at OFF in order to use
the fhn settings (on the mode control).
Note: On some models,the ENERGY SRVER
feature cannot be set on the air conditioner.
It mustbe set using the remote control.
O CIRCULAIRE(on some models)
For continuous side-to-side air circulation
(cool settings only'), set the Circulaire switch
to ON.
For fixed side-to-side air direction, turn ON
until the desired air direction is obvained,
dmn turn it OFF..
O TIMER
Pad
ON-When the air conditioner is off; it can be
set to automatically come on in f to 12 hours
at its previous setting. Each touch will set the
timer in hours.
O
0FF-When the air conditioner is on, it can be
set to antomatically turn off in f to 12 hours.
Each touch will set the timer in hours. After
the timer has been on for 30 minutes, the
temperature will antomatically rise 2°E and
after another 30 minutes, it will automatically
rise 2°F again. _l]ae temperature will then stay
the same until the timer goes OFF.
TOcancel the timer, press the TIMER pad until
the display time disappears.
Remote Control Signal Receiver
Remote Control
/;S_ T o ensure
proper operation,
aim the
remote control at the signal receiver
on the air conditioner.
/TS_ 'Ilm remote control signal has a range
of up to 21 feet.
_ Make sure nothing is between the air
conditioner and the remote control
that could block the signal.
_ Make sure batmries are fresh and installed
correctly as indicated on the remote control.
4