Touch Pad Models - GE AGL12 Owner's Manual And Installation Instructions

About the controlson the air conditionermmodels with touchpads.
Features and appearance will vary.
Cool o n
Fanon
Energy
Saver OR
orgy
on
Cool on
Air ConditionerControls
RemoteControl
Controls
ON/OFF Pad
TtlYns air condi_onei" on and o_'.
Oisplav
Shows the set temperature or time remaining
on tiIlleI:
MODE
Use to set tile air conditioner to
COOL
or
FANnlode.
Increase •/Decrease • Pads
Use to set temperatm'e when in COOL mode.
O FAN Pad
Use to set the tm_ speed to LOW(FI),MED (F2)
or HIGH(F3).
ENERGYSAVER (on some models)
Controls tile tim.
ON--The fan and compressor cycle on and
off. This results in wider variations of room
temperature and humidit,i. Nommlly used
when the room is unoccupied. Note: The fan
will continue to run for a short time after the
compressor cycles off
OFF--The tim runs all tile time, while tile
COIIlI)I'eSSOI" cycles
on _lll(l Off',
This teature must be set at OFFin order to
use the tim settim,s (on the mode control).
Note: On some models,the ENERGY SAVER
feature cannot be set on the air conditioner.
It must be set
using
the remote control
CIRCULAIRE(on some models)
For contimu)us side-to-side air circulation
(cool settings only), set tile Circulaire switch
to ON.
For fixed side-to-side air direction, tm'n ON
tmtil tile desired air direction is obt;fined,
then tm'n it
OFF.
@
TIMER Pad
ON--_._]mn tile air conditioner is oil it can be
set to automatically come on in ] to ] 2 hom_
at its I)revious setting. Each touch will set tile
timer in hom_.
OFF--X_qmn
tile air conditioner is on, it can
be set to automatically tm'n offin 1 to 12
hom_. Each touch will set tile timer in hom_.
O
To cancel the timer, press tile TIMER pad until
tile display time disappears.
Remote Control Signal Receiver
Remote Control
!i_:To ensure proper operation, aim tile
remote control at tile signal receixer
on tile air conditione_:
!i?:The remote control signal has a range
of up to 21 teet.
_: Make sure nothing is between tile air
conditioner and tile reillote control
that could block the signal.
_: Make sure batteries are fl'esh and installed
correctly as indicated on the remote control.
4