Touch Pad Models - GE AGV10 Owner's Manual And Installation Instructions

About the controlson the air conditionermmodels with touchpads.
Features and appearance will vary.
Cool on -
Fan on
Energy
Saveror
Energy
Saveron
on
Cool on 0
0
@
FAN SPEED
TIMER MODE
Air ConditionerControls
Remote Control
Controls
O ON/OFF Pad
TtlFIIS air coilditioilei" oi1 aIld ()_.
Oisplav
Shows tile set temperature or time remaining
011 tiIlleI:
O MODE
Use to set tile air conditioner to COOLor
FAN mode.
Increase •/Decrease • Pads
Use to set temperature when in COOLmode.
O FAN Pad
Use to set the fire speed to LOW(FI), MED (F2)
or HIGH (F3).
O ENERGYSAVER
(on some models)
Controls tile tim.
ON--The tim and compressor cycle on and
off. This results in wider \m'iations of room
temperature and humidity. Nommllv used
when the room is tmoccupied.
NOTE"Thefan
will continue to run for a short t/me after the
compressorcyciesoff.
OFF--The
tim rtms all tile time, while tile
compressor cycles on and off.
This fi_atm'e must be set at OFFin order to
use tile tim settings (on tile mode control).
NOTE" Onsome models, the ENERGY SAVERfeature
cannot be set on the air conditioner /t must be set using
the remote control.
O CIRCULAIRE (on some models)
For (olltiIltlOt/S side-to-side air circulation
(cool settings only), set tile Circulaire switch
to ON.
For fixed side-to-side air direction, mrn ON
tmtil tile desired air direction is obt;fined,
then turn it OFF.
O TIMER Pad
ON--'_._hen tile air conditioner is off, it can be
set to automatically come on in 1 to 12 hours
or 1 to 24 hem's
(depending on model) at its
previous setting. Each touch of tile TIMER pad
or tile INCREASE •/DECREASE•
pads
(depending on model) will set tile timer
in hours.
OFFi\'_llen
tile air conditioner is on, it can be
set to automatically tun_ off in 1 to 12 hem's or
1 to 24 hom_ (depending on model). Each
touch of tile TIMER pad or tile INCREASE• /
DECREASE• pads (depending on model) will
set tile
till/er ill hotlI_.
Tocancel the timer, press tile 77MERpad /mfil
tile display time disappears.
O Remote Control Signal Receiver
4
Remote Control
::Ji:: To ensm'e proper
operation, aim tile remote
control at the signal receiver on tile air
Collditiollei:
iJi:: T ile remote control signal has a range of
up to 21 feet.
::Ji:: Make sure nothing
is between tile air conditioner
and the remote control that could block the
signal,
::Ji:: Make sure batteries are fl'esh and installed
correctly as indicated on tile remote control.