Touch Pad Models - GE AG_18 Owner's Manual & Installation Instructions

About the controls on the air conditioner–models with touch pads.
Features and appearance will vary.
Air Conditioner Controls
Controls
ON/OFF Pad
Turns air conditioner on and off.
Display
Shows the set temperature or time remaining
on timer.
MODE
Use to set the air conditioner to COOL or
FAN mode.
Increase
Use to set temperature when in COOL mode.
FAN Pad
Use to set the fan speed to LOW (F1), MED (F2)
or HIGH (F3).
CIRCULAIRE
For continuous side-to-side air circulation
(cool settings only), set the Circulaire switch
to ON .
For fixed side-to-side air direction, set the
Circulaire switch to ON until the desired air
direction is obtained, then move it to OFF .
Remote Control
To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
The remote control signal has a range of up
4 to 21 feet.
/Decrease Pads
Remote Control
TIMER Pad
ON– When the air conditioner is off, it can be
set to automatically come on in 1 to 12 hours
at its previous setting. Each touch will set the
timer in hours.
OFF– When the air conditioner is on, it can be
set to automatically turn off in 1 to 12 hours.
Each touch will set the timer in hours. After
the timer has been on for 30 minutes, the
temperature will automatically rise 2°F, and
after another 30 minutes, it will automatically
rise 2°F again. The temperature will then stay
the same until the timer goes OFF .
To cancel the timer, press the TIMER pad
until the display time disappears.
Remote Control Signal Receiver
Make sure nothing is between the air
conditioner and the remote control
that could block the signal.
Make sure batteries are fresh and installed
correctly–see the Care and Cleaning section.