Installation Instructions - GE GSS25LGMBBB Owner's Manual And Installation

Installation
Instructions
Refrigerato
Models 25 and 27
ii
,ll,lllUll iii i iiiilUll ,11111,11111111,1111111 iii ii Questions?Call 800.GE.CARES (800.432.2737)or
V isit
o_,r W ebsite
at:
GEAppliances.com
In Canada, call 1.800.361.3400or Visit
our _\:ebsite
at- geappliances.ca
I ,,,H_',H,,,HHU_I,,H_ ill ll_ II II H_ °
I
BEFORE YOU BEGIN
Read these instructions completely and carefully°
• IMPORTANT - Save t hese
instructions fm local inspector's use
• IMPORTANT - Observe all
governing codes and ordinances
• Note to Installer - Be sure to leavethese
instructions with the Consumei:
• Note to Consumer
- Keep these instructions
for future reference.
• Skill level - Installation of this appliance requires
basic mechanical skills
• Completion time - Refrigerator Installation
15 minutes
• Proper installation is tile responsibility of the
installer:
• Product failure due to improper installation is not
covered undm the Warranty
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS)
If the refrigerator has an icemaker, it _vill have to be
connected to a cold water line. AGE water supply kit
(containing tubing, shutoff
valve,
fittings and
instructions) is available at extra cost flora your dealer;
by visiting our Website at GEAppliances.com
(in Canada at geappliances.ea) m from Parts and
Accessories, 800,626,2002 (in Canada 1.888.261 3055).,
REFRIGERATOR LOCATION
* Do not install tile ref}igerator' where file temperature
will go below 60°F (16°C) because it ,vii1not run often
enough to maintain proper temperattues..
• Do not install file _efkigerator where ttle temperature
will go above 100°F (37°C) because it will not perform
properly
• Install it on a floor strong enough to support it fully
loaded.
CLEARANCES
Allow the following clearances for ease of installation,
prope_ air circulation and plumbing and electrical
connections:
• Sides 1/8" (4 ram)
• Top 1" (9_5ram)
• Back 1" (-95 rnm)
I I IIIII IIII
ROLLERS
The rollers have 3 purposes:
nl RoUers adjust so dae doors close on dleir own when
opened about halfivay. (Raise Ore front about 5/8"
[16 ram] from die floor),
II Rollers adjust so the refiigerator is firmly positioned
on d_e floor and does not wobble.
[] Rollers allow you to move the refrigerator' away fiom
the wall for deaning
Final leveling adjustments should be made after
the refrigerator has been installed
To adjust the rollers:
Turn the roller adjusting screws clockwise to raise the
refiigerator, counterclockwise to lower itoUse a 3/8"
hex socket or wrench, m m_ adjustable wrench
RoIleradjustingscrew
17