Advertisement
Power Take-Off (PTO) Switch
o
1
Engages (2) and disengages (1) mower
blades.
Steering
Levers
Reverse (1)- Pull both steering levers
backward.
Forward (2) - Push both steering
levers forward.
Left (3) - Pull left steering lever back
or push right steering lever forward or
a combination of both.
Right (4) - Pull right steering lever
back or push left steering lever
forward or a combination of both.
NOTE: To stop, return both steering levers to
neutral.
NOTE: The steering levers must be in the
neutral position to start the engine.
NOTE: The parking brake must be
disengaged
prior to moving the steering
levers from the neutral position.
Mower
Lift Pedal (Figure
5)
Raises and lowers mower deck.
Press mower lift pedal and install adjustment
pin in the desired adjustment
hole.
3
2
2. Adjustment
1. Mower Lift
Pedal
Hole
3. Adjustment Pin
Figure 5
NOTE: The adjustment
pin is used to set the
height of the mower deck. See
SPECIFICATIONS
on page 30 for cutting
height dimensions.
Fuel
Level
Slot in seat plate shows the fuel level in the
tank. Refill when level gets to bottom of slot.
FILLING FUEL TANK
1. Clean fuel cap and surrounding area to
prevent dust, dirt, and debris from
entering fuel tanks.
2. Remove fuel cap.
IMPORTANT:
See Engine Manual for correct
type and grade of fuel.
3. Tilt seat fully forward to make fuel tank
fully visible.
IMPORTANT: This equipment
and/or its engine may include
emissions control system
components,
required to meet EPA
and/or CARB regulations, that will
only function properly when the fuel
tank has been filled to the
recommended
level. Overfilling may
cause permanent damage to
emissions control system
components.
Filling to
recommended
level ensures a vapor
gap required to allow for fuel
expansion. Pay close attention while
filling the fuel tank to ensure that the
recommended
fuel level inside the
tank is not exceeded. Use a gasoline
container with an appropriately
sized
dispensing spout when filling the
tank. Do not use a funnel or other
device that obstructs the view of the
tank filling process.
4. Fill fuel tank to below bottom of filler
neck. See SPECIFICATIONS
on
page 30 for capacity of fuel tanks.
5. Replace fuel cap.
GB - 13
Advertisement
