Hitachi DZ-MV5000E Instruction Manual page 126

Message
This disc cannot be
used. Please replace
disc.
This disc is finalized.
Finalize is not required.
This disc is recorded by
the NTSC system.
Please replace disc.
UNFORMAT DISC
Use AC adapter/
charger.
Use AC adapter/
charger.
Turn off power.
Write protected.
Check card.
Write protected.
Check disc.
*1
• This message may also appear when dirt adheres to disc. If this message appears when a recorded
disc is recognised immediately after it is inserted, do not repair the disc; remove it and then use the
provided disc cleaning cloth to clean off the dirt before using it.
• This message may also appear when condensation occurs. In this case, do not repair the disc; turn
the DVD video camera/recorder off, wait until it dries out, and then turn it on again.
• If the repair message appears when you turn the DVD video camera/recorder on from off with a
disc loaded after recording on it, choose repair.
• If the repair message appears when recording and playback are normally possible with another
disc – and no condensation occurs and the disc is not dirty – choose repair.
*2
• This message may also appear when dirt adheres to disc. In this case, do not initialise the disc:
Remove it and then use the provided disc cleaning cloth to clean off the dirt before using it.
• This message may also appear when condensation occurs. In this case, do not initialise the disc;
turn the DVD video camera/recorder off, wait until it dries out, and then turn it on again.
• Initialisation will delete all data on disc.
126
Cause & Troubleshooting
A disc that cannot be used on this DVD video camera/recorder
has been loaded. Check the type of disc.
This message will appear if you press the FINALIZE button with a
finalised DVD-RW/DVD-R/+RW loaded in this DVD video camera/
recorder. Finalising the disc is not necessary.
This DVD video camera/recorder can use only discs recorded on
the PAL system. A disc recorded on the NTSC system cannot be
used on this DVD video camera/recorder.
The disc is not initialised or it is damaged.
If this message appears, be sure to initialise the disc on this DVD
video camera/recorder before using it.
Reinitialising even a disc used on this DVD video camera/
recorder may be necessary (initialising will erase all recorded
contents on disc). If this message appears, try to initialise the
disc. If the same message still appears, the disc may be
damaged: Use another disc.
See *2 on this page.
Finalisation is not possible when the DVD video camera/recorder
is powered by a battery: Use the AC adapter/charger for
finalisation.
Scene cannot be repaired when the DVD video camera/recorder
is powered by a battery.
If the AC adapter/charger is unavailable in handy place, remove
the disc, use the opposite side, or use another disc. To repair the
removed disc, insert the disc into the DVD video camera/recorder
afterwards, and connect the AC adapter/charger.
A card with the erase prevention switch locked is inserted: Unlock
the switch.
• A write-protected disc is inserted.
• Release the write-protect using the Disc Navigation menu.
Reference
page
36
112
—
109
11
37, 112
37
36
110