Table of Contents
Advertisement
⒑
7.9 USB Setting
Connect the GPS navigator to PC via the MINI USB port to transmit data, or back up data
from the navigator data to PC.
The GPS navigator provides MASS STORAGE and MS STORAGE modes. Select one in
the USB setting.
7.9.1 MASS STORAGE
1. Have the GPS navigator in operation status and the SD card plugged in the slot;
in the system setting interface to enter USB Option as shown below.
2. Tap
Select MASS STORAGE and tap
3. Connect the MINI USB terminal of the USB cord to the MINI USB port of the GPS
navigator and the standard USB terminal to the USB Host port of PC. Then the PC will
recognize the navigator and prompt the following interface. To disconnect the navigator
from PC and enter USB charging mode, you may select
Close
Exit the FM Setting.
Save
Save current setting.
Use FM
Tick in the box to enable FM function.
Frequency Drag the slide block rightwards (or tap
increase the frequency and leftwards (or tap
reduce the frequency. The frequency range is 88.00
Mhz-108.00 Mhz.
to save it.
28
.
) to
) to
Advertisement
Table of Contents
