Alarm Link To A Position/Tour - EverFocus Eptz3000 User Manual

to enter the tour number you would like to run, and starts the tour after pressing
Enter. To preset a tour before running is necessary.
Preset a one-way tour: Press Set + Tour to preset a one-way tour. The system will
ask you to enter preset position numbers (The positions need to be preset). After
finish entering all positions, press Stop to quit, and then press Enter to save the
tour.
To-and-fro tour mode: Press Shift + Tour to run a to-and-fro tour. The system will
ask you to enter the tour number you would like to run, and starts the tour after
pressing Enter. To preset a tour before running it is necessary.
Note 1: The difference between the One-way tour mode and To-and-fro tour mode is that
the return modes are different. For example: There is a tour with 3 preset positions 1, 2
and 3. The camera runs 1→2→3→1→2→3 in the One-way tour mode, and 1→2→3→2→
1 in the To-and-fro tour mode.
Note 2: You could set a pattern tour. Press Set + Tour, and input 0, press Enter. Sway the
joystick to record the entire tour. Press Stop to stop recording tour. To view this pattern
tour, simply press Tour, and input tour number 0.

4.5. Alarm Link to a Position/Tour

EPTZ3000/EPTZ3000I have 4 alarm inputs that can be set to link to a position or a tour
when an alarm is triggered.
Set an alarm link:
Press F1 to set an alarm link. Enter the alarm number, and then press Enter.
Switch the Joystick up/down to select a position or a tour, enter a position or tour
number, and then press Enter to confirm the alarm link setting.
If you set the position number to 99, the dome will do a 360 degree auto scan or
4-39