Table of Contents
Advertisement
Symptom
Pressing QUICK
• The camcorder enters sleep mode when QUICK
START does not
enter sleep mode.
• Check the following causes:
No scene can be
Is the cursor placed on the scene to be deleted?
deleted.
If the selected scene is framed in red, it can be deleted,
even if you use yellow cursor to select the scene. Check
the colours of the cursor and bar graph on the thumbnail
screen.
Disc cannot be
Did you detach the battery or AC adapter/charger before
removed.
setting the power switch to "OFF"?
(Cover will not
Isn't the camcorder powered off because the battery pack
open.)
is empty?
Is the battery charged?
Connect a charged battery or the AC adapter/charger to
the camcorder, and then turn the power switch to "OFF",
then press down the DISC EJECT switch.
Isn't the power switch set to "ON"? Turn the power
switch to "OFF", and then press the DISC EJECT
switch.
The remote control
Do you operate the remote control toward the remote
does not operate.
control receiver of the camcorder?
If the camcorder's remote control receiver is exposed to
strong light such as direct sunshine or fluorescent light,
the remote control does not work.
Adjust the position or angle of the camcorder.
Is the lithium battery inserted in the remote control?
Check that the polarization of the lithium battery is
correctly set.
The lithium battery may be empty. Replace the battery to
a new one.
Is the camcorder powered on? If not, turn on the
camcorder.
Cause and Correction
START is pressed only while in recording pause mode.
- there is no disc in the camcorder while the power
switch is set to "BD/DVD".
- there is no SD memory card in the camcorder while
the power switch is set to "SD CARD".
- the HDD, disc, or card does not have sufficient
remaining free space.
- An usable disc or card is inserted.
- the disc navigation screen is appearing.
- during playback.
Reference
page
48
107
23, 45
17
—
18
24
155
Advertisement
Table of Contents
