Table of Contents
Advertisement
Setticng Up Record Functions
Switchisng Movie Quality Mode
Choose the movie quality from "XTRA" (only with DVD-RAM disc on DZ-MV238E(AU) and DZ-
MV230E(UK)), "FINE" and "STD".
However, it is recommended that you record critical subjects in the "XTRA1" or "FINE" mode when you
are using a DVD-RAM disc, or in the "FINE" mode with a DVD-R disc.
1
Press the MENU button in the recording pause
status.
The menu screen will appear.
2
U s e t h e j o y s t i c k t o
choose "VIDEO Mode"
on the "Record Func-
tions Setup" screen, and
then press the
ton.
Options will be displayed on the right of
"VIDEO Mode".
The
mark will be attached to the currently se-
lected option.
Block-like noise may appear in recorded image, or the outline of subject image is distored under the
recording conditions listed below: Pan the DVD video camera/recorder as slowly as possible. (Block
noise is likely to appear in the "STD" mode):
•If there is a complicated pattern in background
•If the DVD video camera/recorder is panned or tilted greatly or rapidly
•If subject is moving rapidly even when the DVD video camera/recorder is not moving (as in following
figure on left)
(Image whe n block-like noise occurs)
but-
3
Use the joystick to select
the desired quality
mode, and then press
the
button.
4
Press the MENU button.
The menu screen will disappear.
Movi e quality mode
Note: The "VIDEO Mode" setting will not change
even after the DVD video camera/recorder is
turned off. However, if "XTRA" has been set with
DVD-RAM disc, "FINE" will be set when the disc is
changed.
(Image without block-like noise)
59
Advertisement
Table of Contents
